La Marzocco Modbar EP repair that shows up today. GTA-wide.

Something in the profiling chain has failed: the pre-infusion solenoid, the transducer, or a controller output. We diagnose each, replace the failing part, and recalibrate against a portafilter gauge so the curve runs the way you programmed it.

That tap's gear pump is likely worn. Each tap runs its own gear pump for profiling, and wear flattens the achievable curve. We test each pump against the programmed profile and replace the gear set or the full pump as needed.

Often. Mineral deposit on the transducer port or a drifting transducer throws the reading off. We clean the port, test the signal, and replace the transducer if it is out of spec, then reload the profiles after calibration.

No. It is usually a cable fault between the bar and the module, or a controller hang. We trace the cable, hard-reset, and reflash if needed. The under-counter hardware is usually fine.

The cabinet is where the work is. We access the under-counter module to reach the gear pumps, transducers, group, and controller, and only the tap and display sit on the bar. A clear cabinet makes the service straightforward.

Yes. The module needs ventilation clearance, and a tight cabinet makes it overheat. We confirm the install meets spec and add ducting if it is needed, which also keeps the electronics and pumps reliable.

Effectively, the profiling architecture is shared: gear pumps and transducers driving programmable curves per group or tap. The Modbar difference is the split layout, the tap assembly, and the bar-to-module cabling, which we service as part of the platform.

Yes, that is part of the job. We log the curve on a portafilter gauge before and after the work and re-verify your reference profile before sign-off, so the tap pours the curve you built, not just a working one.

Flat rate for the visit, parts billed at their actual cost on top. You'll hear the rate when you book, and for bigger jobs we quote in writing on-site before any work starts. No estimate that balloons mid-job.

Same-day. Call in the morning and a technician is usually on-site before the day is out; calls placed later in the day book for the next morning. Urgent breakdowns get priority routing.

The GTA and most of the Golden Horseshoe: Toronto through Mississauga, Vaughan, and Markham, out to Oshawa, Hamilton, and Niagara. If you're not sure you're in range, call and we'll tell you straight.

No. We work call by call. Plenty of customers put us on a maintenance schedule eventually, but that's their choice after seeing the work, never a requirement.

Parts carry their manufacturer warranty, and we stand behind our labour: if the same fault recurs, call us and we'll review it. Specific terms are discussed upfront on each job, not promised in marketing copy.

On-site whenever possible, which is most of the time. If a job genuinely needs the bench, like a full boiler rebuild or major electronics work, we'll say so before anything leaves your building.

Call us or send the form on this page. We confirm the machine, the fault, and a time window the same day. If it's urgent, say so and we'll route the nearest technician.

Diagnosis first: we confirm the fault, tell you what caused it, and quote the fix before touching a wrench. Most repairs finish in that same visit because the common wear parts ride on the truck.

High-wear parts for the platforms we service constantly ride on the truck. Anything else we order, usually next-day where suppliers allow, and we tell you the lead time before committing you to anything.

Usually, yes. We service legacy machines for as long as parts can be sourced, and we're honest when a repair stops making financial sense against a replacement. You get the math, you make the call.

Often, but that's not the pitch. We quote against the actual work, not a factory pricing book, and we'll tell you when a manufacturer warranty claim is the better route. Transparency is the value; the price usually follows.

Yes, and we do it by default on the way out. Half of repeat faults trace back to skipped daily cleaning or wrong routine, so the technician walks your team through what actually matters before leaving.